Fixing a Washing Machine

Depending on the type of damage involved, learning how to fix a washing machine may be more or less complicated.

Fixing a washing machine if the fault is in the programmer

One of the most common breakdowns often occur in the programmer, as it consists of a large number of switches that activate the other electrical components of the machine. The programmer essentially consists of two parts clearly distinguished: the first is made up of switches. Recognize that needs repair when turning the knob and the developer does not connect the valve to carry water or the motor that spins the drum. In this case we should replace it. To no mistake in the position of each cable connecting the terminals will we go to the programmer again as we go down the old one by one. The second part is the motor reducer with a small group of pine nuts that turns the programmer step by step. If the engine is burned because we will know what the programmer does not rotate automatically to move from one phase to another washing. We can change the engine, we will by far cheaper than changing the entire program.

Fixing a washing machine if it does not heat the water or slightly heated

Another failure is often the case that the system to heat water. It is composed of two parts: thermostat and resistance. Lime water tends to attack the resistance is necessary, in principle, putting the thermostat at a higher temperature for hot like that. Anyway, lime often end up destroying the resistance, so they must be replaced. To change it must drop rubber drain of the drum and, after removing the nuts of the resistance, push inwards to remove the feeding tube drainage. The thermostat is coupled with a small copper pipe to a thermal probe that is at the bottom of the drum, close to the resistance. Being in contact with water also affects the lime. If it breaks down the thermostat or its probe, we will replace the two since they are united to form the same piece.

Fixing a washing machine if the engine does not rotate or spins

Although less common, there may also be a breakdown in the main engine. If burning is more profitable to change it to a new winding. When the strap on the skates of the motor pulley, loosen one of the two screws that hold it and, with leverage in it, strain the block. And hold the lever tight new screw. In the event that the belt is damaged, the change with a new one.

Fixing a washing machine, if not evacuated dirty water

We remove the drain plug to check that it has not obstructed anything in the blades of the circulator. Drain will review the engine that is at the bottom of the washer attached to the rubber that we mentioned earlier. We can apply flow directly to see if it works. If not, what we change.

Fixing a washing machine if you do not load water

We reviewed it comes to the flow valve, which is connected to the rubber supply of water. If there is no flow, the developer fails. If it receives, the fault is in the valve and will have to change it.

Fixing a washing machine, if not enough water or cargo load of more

This is what regulates a pressure at the top of the washing machine and is connected by a thin rubber to the bottom of the drum. This device comes with the factory settings so it is highly recommended not to change them. If necessary, because the load washing machine or a lot of little water, by the leaking of the detergent drawer, we can regulate it by using screws that leads. Where is regulated, we miss a drop of sealer so as not to loose the screws. If it does not work, what will change.

Fixing a washing machine if anything does not work

Check that the power cord transmits the flow to the machine and that the switch of security that takes into the lock of the door is not damaged.

Leave a Reply

Your email address will not be published. Required fields are marked *


six − = 5